Overview - Front Door Trim Panel
1 - Pull Handle with Armrest
Removing and installing. Refer to
→ Chapter "Front Pull Handle, Removing and Installing".
2 - Switch Mount
Special tools and workshop equipment required
Wedge Set -T10383-
Wedge Set - Wedge 1 -T10383/1-
Removing
- Switch off the ignition.
- Unclip the decorative trim -1-
using the -T10383/1-
Removing
- Remove the door trim panel. Refer to
→ Chapter "Front Door Trim Panel, Removing and Installing".
- Place the door trim panel on a soft surface.
- Equipped on some mod
Removing
- Remove the engine cover. Refer to
→ Engine Mechanical; Rep. Gr.10; Engine Cover; Engine Cover,
Removing and Installing.
- For vehicles that have a pass-through for the coolant lines
through the plenum chamber bulkhead, drain the coolant. Refer to
→ Eng
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts catalog prior to
starting procedure.
Mandatory Replacement Parts
Nut - for Adjusting Bolt
Procedure
- Remove the nut -1- from the
subframe/rear lower transverse link threaded connec