Applies to: vehicles with navigation system
Fig. 140 Route guidance not started
The navigation system directs you to your destination,
around traffic incidents, and on alternative
routes, if desired.
SEE MORE:
To complete the procedure, a second technician is required to be at the
following position.
Special tools and workshop equipment
required
Pliers -T40172C-
Adapter -T40172/1-
Removing
- Push in the front wheels and loosen the wheel housing liner near
the front bumper cover. Refer to
→&
1 - Clamp
Replace after removing
Tensioning. Refer to
→ Chapter "Clamp on Triple Roller Joint and Outer Joint, Tensioning".
2 - CV Boot
If the drive axle has a peened triple roller joint, then the triple
roller joint has an adapter installed
The CV boot must fit