Audi A4: Speed warning system
Description
Applies to: vehicles with speed warning system
The speed warning system helps the driver to stay below a specified maximum speed. A warning threshold can be set in the MMI for this purpose.
Once the speed slightly exceeds the stored threshold, the speed warning system will alert the driver with an indicator in the instrument cluster and a warning tone. Once the speed drops below the stored maximum speed, the indicator will turn off.
Setting a threshold is recommended if you would like to be reminded when you reach a certain maximum speed. Situations where you may want to do so include driving in a country with a general speed limit or if there is a specified maximum speed for winter tires.
Tips
Regardless of the speed warning system, you should always monitor your speed using the speedometer and make sure you are adhering to the legal speed limit.
Setting the warning threshold
Applies to: vehicles with speed warning system
- Applies to: MMI: Select on the home screen: VEHICLE > Driver assistance > Speed warning.
Messages
Applies to: vehicles with speed warning system
The following messages may appear depending on the vehicle equipment:
.png)
Manually set speed limit XX
mph
(km/h) exceeded
The stored speed was exceeded.
READ NEXT:
Camera-based traffic sign recognition
Description
Applies to: vehicles with camera-based traffic sign recognition
Fig. 104 Instrument cluster: traffic sign recognition
The traffic sign recognition shows the traffic
signs detected by th
Traffic light information
Description
Applies to: vehicles with traffic light information
Fig. 105 Instrument cluster: traffic light information display
The traffic light information gives you a speed
recommendation in orde
Lap timer
Introduction
Applies to: vehicles with lap timer
You can record and evaluate lap times with the
lap timer. You can operate the lap timer using the
multifunction steering wheel.
Opening the lap timer
SEE MORE:
Rear Lid, Removing and Installing
Rear Lid, Removing and Installing, Sedan
To complete the procedure, a second technician is required to be at
the following position.
Removing
- Remove the rear lid lower trim panel. Refer to
→ Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels;
Rear Lid Lower Trim
Repairing a Wire 0.35 mm 2 or Greater with
Individual Crimp Connector
Procedure
- Free up the wire to be repaired approximately 20 cm on both
sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harnesses carefully.
- If necessary, removing the wiring harness wrapping using a
knife.
- Cut out the dam
