Audi A4: Subframe
READ NEXT:
Overview - Subframe
Overview - Subframe, FWD
Caution
There is a risk of damaging the threads on the subframe
threaded connection to the body.
The subframe bolts on the body must not be loosened or
tightened
Subframe, Securing
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Gearbox Support -T40173-
Locating Pins -
Subframe, Removing and Installing
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts catalog prior to
starting procedure.
Mandatory Replacement Parts
Bolt - Bonded Rubber Bu
SEE MORE:
Front Axle Camber, Centering
Note
Camber cannot be adjusted.
Camber can be centered evenly within specified tolerance
range by shifting subframe.
Procedure
- Remove the noise insulation. Refer to
→ Body Exterior; Rep. Gr.66; Noise Insulation; Noise Insulation,
Removing and Installing.
-
Rearview Camera System, Calibrating
Calibration Unit -VAS6350A-, Installing and Aligning
After performing repair work on the vehicle, it may be
necessary to re-calibrate the rearview camera system. In detail,
this is the case after:
Rearview Camera -R189- removal and installation
Collision repairs on rear lid
Changes to the axle
© 2019-2026 Copyright www.audia4b9.com
